Proxim ORINOCO AP-2000 Manuel d'utilisateur télécharger pdf (Page 48)

Performing Advanced Configuration

stations that may not be able to receive multicast packets at the higher rates; in this case, you should set Multicast

Rate to 1 or 2 Mbits/sec.

Figure 4-6 1 Mbits/s and 11 Mbits/s Multicast Rates

NOTE

There is an inter-dependent relationship between the Distance between APs and the Multicast Rate. In

general, larger systems operate at a lower average transmit rate. The variation between Multicast Rate and

Distance Between APs is presented in the following table:

The Distance Between APs must be set before the Multicast Rate, because when you select the Distance

Between APs, the appropriate range of Multicast values automatically populates the drop-down menu. This

feature is not available if you are using an ORiNOCO ComboCard or a non-ORiNOCO client with the AP.

Wireless (802.11b/g)

You can configure the following radio parameters for an 802.11b/g AP:

NOTE

You must reboot the Access Point before any changes to these parameters take effect.

• Operational Mode: An 802.11b/g wireless interface can be configured to operate in the following modes:

– 802.11b mode only: The radio uses the 802.11b standard only.

– 802.11g mode only: The radio is optimized to communicate with 802.11g devices. This setting will provide

the best results if this radio interface will only communicate with 802.11g devices.

1.0 Mbit/s 2.0 Mbits/s 5.5 Mbits/s 11 Mbits/s

Large yes yes

Medium yes yes yes

Small yes yes yes yes

Minicell yes yes yes yes

Microcell yes yes yes yes

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 243 244

Pas de commentaire

Proxim ORINOCO AP-2000 Manuel d'utilisateur Page 48