Proxim ORiNOCO AP-2500 Manuel d'utilisateur télécharger pdf (Page 201)

201

Using the Command Line Interface

For the wireless card in Slot B

You can set up to four encryption keys. This example describes setting encryption Key 2 on the wireless card in Slot B.

[Device Name]>set wifsec 4 encrypt enable encryptkey 2

<WEP key (5-13 characters long depending on card type)> encryptkeytx 2

[Device Name]>show wifsec<CR>

Figure A-13 Result of “show wifsec” CLI Command

Change Passwords

[Device Name]>passwd <old password> <new password> <confirm password> (CLI password)

[Device Name]>set httppasswd <new password>

[Device Name]>set snmprpasswd <new password> (SNMP read password)

[Device Name]>set snmprwpasswd <new password> (SNMP read/write password)

[Device Name]>reboot 0

CAUTION

Proxim strongly urges you to change the default passwords to restrict access to your network devices to

authorized personnel. If you lose or forget your password settings, you can always perform the Reset to

Factory Default Procedure.

Other Network Settings

There are other configuration settings that you may want to set for your AP-2500 unit. Examples are provided below.

– VLAN Management

– Change your Wireless Interface Settings

– Set Interface Management Services

VLAN Management

Add Entry to VLAN ID Table

– 3 = wireless card in Slot A

– 4 = wireless card in Slot B

[Device Name]>set vlanidtbl <index (1 or 2)> id <0 (disable) o 1-4094>

[Device Name]>reboot 0

[Device Name]>show vlanidtbl

1 2 ... 196 197 198 199 200 201 202 203 204 205 206 ... 249 250

Pas de commentaire

Proxim ORiNOCO AP-2500 Manuel d'utilisateur Page 201