Proxim ORINOCO AP-2000 Manuel d'utilisateur télécharger pdf (Page 63)

Performing Advanced Configuration

Configuring Hardware Configuration Reset

Perform the following procedure to configure Hardware Configuration Reset and to set the Configuration Reset

Password.

1. Click Configure -> Management -> CHRD.

2. Check (enable) or uncheck (disable) the Enable Hardware Configuration Reset checkbox.

3. Change the default Configuration Reset Password in the “Configuration Reset Password” and “Confirm” fields.

NOTE

It is important to safely store the configuration reset password. If a user forgets the configuration reset

password, the user will be unable to reset the AP to factory default configuration if the AP becomes

inaccessible and the hardware configuration reset functionality is disabled.

Figure 4-15 Hardware Configuration Reset

Procedure to Reset Configuration via the Serial Interface

1. During boot up, observe the message output on the serial interface.

The AP prompts the user with the message: “Press ctrl-R in 3 seconds to choose configuration reset option.”

2. Enter ctrl-R within 3 seconds after being prompted.

The AP prompts the user with “Press ctrl-Z to continue with normal boot up or enter password to reset configuration.” If

the user enters ctrl-Z, the AP continues to boot with the stored configuration.

3. Enter the configuration reset password. The default configuration reset password is “public”.

When the correct configuration reset password is entered, the AP gets reset to factory defaults and displays the

message “AP has been reset to Factory Default Settings.” The AP continues to boot up. If an incorrect configuration

reset password is entered, the AP shows an error message and reprompts the user. If the incorrect password is

entered three times in a row, the AP proceeds to boot up.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 243 244

Pas de commentaire

Proxim ORINOCO AP-2000 Manuel d'utilisateur Page 63